How do i add my D-Link router into my case?

[monny]

I'm just curious if anyone knew how, I've seen a hub in a case before but i want to add my router. Right now it takes up space on my desk underneath my flood light.

[RicheemxX]

I never seen it but basically all you'd have to do is find a spot it will fit maybe add some double sided tape to the bottom so it won't move around then make sure your route the wires out of the way of any fans cards ect. and drill some holes for the power wire as well as all your network wires to exit your case. I'n most cases it should fit easily in the front under the fan{depending on how big your router is}
I don't really see the need for that as a router doesn't take that much space and if you plan on adding other computers later you'll have to pull open the case but hey whatever you'd like to save the few inches of space. You'll also be adding some extra heat to the case, it might not be much but you should keep an eye on that.

[Neř]

router inside a computer counds like a cool idea, but how about computer inside a router

-Neř

[kantlivelong]

i wouldnt recommend it unless you are able to provide a great amount of cooling. a hub/router/switch creates a great deal of heat..

[MDS]

Originally posted by kantlivelong
i wouldnt recommend it unless you are able to provide a great amount of cooling. a hub/router/swift creates a great deal of heat..

Totally agree, to much heat to put inside and raise your system temps. Not to mention having to open case every-time and or remove systems from network.

[willy_ph]

Neř, I've considered putting a PC inside an old rackmountable hub. It's possible to accomplish, much like a rackmounted computer.

To the original post, it's possible to do it. Just mount it so the ports originate at the back of the pc and extend the leads on the LEDs so you can have them show up at the front of your case, or on the side. The only problem you'd have if you were looking to completely stealth the router would be the problem of the power cord for the router. However, altering the power from the power supply could solve that problem. if it runs on DC power, of course.