Hello. I flashed the 200i with firmware upgrade domestic version 1.30 meaning to flash with 1.03. Webramp's site said that you had to have 1.03 before you could flash to 1.50.
Here is the site
www.rampnet.com
After the (possible) incorrect firmware update I cannot get dhcp and or use the http admin page for this webramp. I can force my network card to have an ip address of 192.168.1.2 with default gateway of 192.168.1.1 and be able to telnet into the router but nothing else. If anyone has any suggestions please post. I have emailed webramp tech support and currently awaiting a email back.
I am not sure why firmware 1.30 would not work but 1.03 might. I decided to do the firmware upgrade because the webramp analog dial up line was not disconnecting after the specified idle time set.
I am going to try to get the latest firmware update which is 1.50 for this model. I was thinking that there might be away within telnet to upgrade the firmware but have not had any luck thus far.
Thanks, for posting any replies......
Linear Mode
