Information about drawing’s what is M10 and H6

[Pamlor]

Eeee if it says in a drawing that the diameter is M10 and H6, what is the diameter then and how deep is the hole.

Thx for any given answers

[Pamlor]

I have to make this peace by a cad program but now I am unsure of the diameter and the depth.

http://www.hostmysig.com/data/pamlor/Drawing.JPG

[puk]

M10(metric 10)
**for coarse pitch(1.5 mm) tapping diameter=8.5mm
**for fine pitch(1.25 mm) tapping diameter=8.7mm

H6(tolerance class)-->the tolerance range is 0.00/+0.006mm

a pic of the dwg will help!! w/"how deep is the hole"

hth
puk

[Pamlor]

What do dwg stand for, what i wonder is how deep i should make the hole in the cad model.

http://www.hostmysig.com/data/pamlor/drawing2.JPG

[Pamlor]

Btw when u say pitch u mean the lace of the screw? if that is the case what would the angel be?.

[Pamlor]

Aww none can help.. :cry:, anyway thx for the help .

[Pamlor]

Originally posted by puk
M10(metric 10)
**for coarse pitch(1.5 mm) tapping diameter=8.5mm
**for fine pitch(1.25 mm) tapping diameter=8.7mm

H6(tolerance class)-->the tolerance range is 0.00/+0.006mm

a pic of the dwg will help!! w/"how deep is the hole"

hth
puk

Hrm about the diameter as it m10 like 10 * 8 = 8mm, and then if m5 5*8 = 4 mm.