 » 
ITOX G370lf10 Rev. A1-Processor installed & BIos Setup Lags
This Thread is to inquire of your expertise out there....
I have a used ITOX g370lf10 Rev.A1
(A revision Controlled Motherboard)
This Board Posted fine after i installed a P3 733 mhz CPU & 32mb sdram however it didn't detect IDE's
So I cleared the CMOS, The IDE's Detected FINE
But I noted that the CPU is now at 550mhz
this is because the defaults are loading..as Stated in error message...As per the instructions (press f1 to resume or del to enter setup,to change the CPU speed)
I press delete to enter setup to adjust processor speed...
I get exactly 9 keystrokes in before the setupsystem freezes and will not accept input from the key board....
9 keystrokes isn't enough and the f7 ETC procedures don't work freezes on notice....
I am beginning to suspect the keyboard-I have tried 4 different ones with the same results...
Anyone have any clue what is going on here and how to possibly remedy this problem?
| 
Linear Mode
