Help.......will not post

[tk1780]

HELP I have a K7s5a and changed the chip to an XP 1800+. It booted fine. However the FSB was set to 100. I went into the Cheepoman Bios and changed the FSB from 100/100 to 133/133 and now it will not post.

The hard drive turns on and it tries to use the CD but will not post.

Any thoughts?

[jmebonner]

Clear your cmos, then try it again.

[athlonxpguy]

And it will run at 100mhz? Also, check the CPU list

What PCB version is yours?

[tk1780]

I cleared the CMOS and it booted at FSB 100, but when i tried it at 133 it would not post again. The CPU is only an XP 1800+ so it should work fine.

I'm stumped?

Thanks