New harddrive Need help

[Dark_Smoke]

Ok i got a new HDD for my other comp, not brand new just new to me. pulled the old one and stuck the new one in.

Now i cant get anything when i turn it on. i get a soild HDD light on the case but nothing comes up on the monitor,

I checked the connections and there all good, what could it be???? Thanx

Sounds like maybe you've got the IDE cable in upside down? That's all I can think of for that. Usually if the jumpers are wrong, it'll still boot and you can get to the BIOS. Either that or the hard drive is dead.

[Dark_Smoke]

yea i checked the cable, its all good and right,
I cant even get to the BOIS now that i pulled the other HDD, Im stumped

[cadetstimp]

Can you get to the BIOS even if you pull all HDD?

Maybe the new drive is bad and it is affecting the mobo IDE controller.

Also, if the drive is newer and very large - maybe your mobo can't handle the capacity of the new drive

[rpertusio]

Have you checked out the jumpers on the drive? Are the jumpers in the same position as the old drive? (Master/Slave/CableSelect)

- rp

[Dark_Smoke]

yea all the jumpers and cables are right, i pulled the HDD all together and still get the soild HDD light and no pic.

I plugged the comp into this monitor im using now and still nothing but after about 3 seconds after i turned on the comp after hookin it up to this monitor i got a loud humming or buzing noise so i shut it down fast.


I threw the HDD in the comp im using now and it work perfect. no bad sectors or anything

[Foggy]

Did you try to reset the BIOS? use the jumpers on the MOBO and reset the BIOS.

[Dark_Smoke]

yea i did and still nothing