675,865 reviews,
402 today

Bootlegger · 08-21-2003, 08:58 PM

Ok, here's what my mobo looks like (USB pin headers circled and enlarged):

It's an EliteGroup L7VMM2.

I need some help on how to hook my front USB panel up.

Here's what the connectors look like (did a li'l editing in paint, 'cause I found the pic on the web lol):

So, I'm trying to figure out which way everything goes on. If anyone could help, I'd greatly appreciate it.

Thanks, guys.

Buzioid · 08-21-2003, 09:01 PM

The ground goes to the LEFT, where that pin is missing on the mobo, each goes the same way. The pin under the missing pin is also an extra ground.
Good Luck!

Bootlegger · 08-21-2003, 09:04 PM

Ok, thanks man. But which one (VCC1, VCC2) goes on the four pins?

Buzioid · 08-21-2003, 09:06 PM

Stack them, VCC1 goes on top or bottom, the other on the other one, just line up the GND to the left on both.

Etruscan · 08-21-2003, 09:07 PM

Go to ecsusa.com and look under support or downloads. There you will find a diagram for your board. You may even find the right pinout in your manual.

Bootlegger · 08-21-2003, 09:09 PM

You 100% sure that it doesn't matter which one goes on top? lol I just fried a motherboard previous to coming here because I'm a tard and wasn't paying attention.

Buzioid · 08-21-2003, 09:21 PM

Yes, they just goto the USB ports, both are exactally the same thing, taking 4 wires to the front of the computer. I don't see what the difference is, I had mine hooked up both ways, and it worked.