Tweaki license code

[batmeat]

Is there anyway I can figure out my license code after i have already installed tweaki? I'm formatting a computer and I never saved my license code. Is it stored in the registry by chance?

[batmeat]

Nobody knows? I searched the registry to no avail. I haven't heard back from Jermar Software either.

[Jack Hannibal]

To prevent registration issues with Tweaki backup the file "JerMar Software Tweaki...for Power Users.SLX" located in the folder where you installed Tweaki. Should you need to install and uninstall Tweaki after it has been registered, copying this file back into Tweaki's installation folder will prevent the need to re-enter registration information. Just make certain you copy the file back into the Tweaki install folder BEFORE running Tweaki for the first time. Should you ever need a new unlock code you can find information on how to get one at the Tweaki update page. However, if you make a copy of the *.SLX file and insure it remains in the Tweaki install folder you should never need an unlock code again.

Hope that helps

You might also want to read the other items here:
http://www.jermar.com/faq.htm

[phlatline]

You will not use these forums for the purposes of sharing or distributing viruses, licenses, protected registration information, illegal software keys, key generators, cracks, or any other information designed to cause harm, damage, fear, terror, loss of productivity, time or work, or to allow unlawful and illegal access to any computer hardware, software, network, or any other system.



GroundZero3

[batmeat]

The SLX file didn't work. Sigh

[SeanC]

Have you tried contacting the makers of Tweaki?

Sean

[batmeat]

Yes to no avail. I'm just going to buy it again. It was only $20.00 not to bad.