Jetway V266B Motherboard problem

[PicoTTo2003]

Hi people, wondering if somebody could give me a hand.

Hears my spec first:-

Windows xp
Athlon xp2000
Motherboard - Jetway V266B/VIA KT266A chipset

When i purchased the above motherboard, it came with a program called winbond doctor, which measures my cpu temp and voltages etc.

I would like to say first, that this program worked fine for the last 1/1.5 years. Now when i open this program up i get apx 10 error messages, consisting of "cpu temp is to high", "V12 voltage to high" etc (for those who are familiar with this program will understand what im on about). As i say this was running fine before.
It states my sys temp and cpu temp is 127c, which i know is wrong because from cold start up it reads that.

Ive reinstalled my bios and the mentioned program, winbond, yet still no joy.

Any help would be very grateful

Thank-you for your time

A Brit in dispair

[tankie45]

Dear User, I think you will find that after a little while Winbond Doctor becomes very unstable with WinXP, for some strange reason it does not like it . Iv'e had some strange readings as well and on further research found it interferes with XP,ie, XP does not seem to appreciate anything interfering with it's initialisation(most of the utils on the M/board setup disk especially the "Magic" utility. since reinstall i have managed to get a stable reading on temp from not using Winbond

Hope this helps
Tankie