Celeron (old) Temperatures

[Telexen]

What are the average temperatures for older Celerons, specifically a 333mhz (O/C 417mhz) Socket 370? I have an adapter so it's in a Slot 1 board, so I have no idea what my temperatures are.

I'm wondering if it will run decently without a fan mounted to the heatsink..I'm out of these little fans and every one I put on there ends up rattling after a few days, and it's ANNOYING.

This box is my NAT/Router/Firewall, so though it's working all the time it's never under much load.

[hgTafka]

i have 2 computers, one is p2 300mhz, i think the temperatures should be the same, i get no more than 35 degreeds or even less!! the only thing what is heating up the machine is a voodoo1 graphics card(it gets extremely hot!! about 45-50 degreez, too hot to toutch it with ya bear hands...)

[Siliconjunkie]

You could try doing something similar to what Zalman does and mount an 80mm fan to blow on the heat sink. Run it at a low speed.

Also, un-overclock it. I run my firewall/proxy on A PII 233 and never get any load (load average: 0.02, 0.03, 0.00). That should cool you down a bit. Maybe underclock it even.

[Telexen]

Maybe, but I don't have a low speed 80mm fan anymore either.

The CPU has been overclocked since it was built...jumper settings...too big of a pain to change