No power to new K7T Turbo2 Mobo

[RudyK]

I have had to replace my mobo for my old system with a new K7T Turbo2 mobo from MSI. I hooked everything up and switched on the power and got no response. The case fan wouldn't even run. I removed all components and started again, same result. I put the old board back in just to make sure the power supply and switch were working and the fans started imediately. I reninstalled the KT7 mother board with only the processor(AMD Thunderbird 900mHz), one 128 meg stick of PC 133 and a maxtor 40 gig hard drive. Nothing. I cleared the CMOS, tried again, nothing. Could the board be bad, or is there something else I can do. I have only built one other system but I had no problems with it. Thanks.
RudyK

[Telexen]

Sounds like it is bad. If you're sure you haven't mistakenly incorrectly installed any vital cables, then you'll need to get this board replaced

[RudyK]

I found out when I changed motherboards one of the brass footings to the old board didn't line up on the new board and was shorting it out. A lesson learned for a newbie computer builder.
RudyK

[Praetorian]

I hope you enjoy your board. I've got the same board (I wrote a review on it too....somewhere), and it's okay. I think it's time for an upgrade though.