Where does it go?

[allenfi]

I'm wanting to use this fan controller and temp monitor

http://www.newegg.com/app/ViewProduc...pa=0&section=3

and there are these 4 thermostat wires with flat copper ends
that the booklet says hook to the heatsink fan!!
Does that sound right?
The manual looks like it written in broken english so it hard to understand.
Does anybody have any idea?

see this link and go to "MANUAL" and see the illustration that i am talking about

Thanks or any input

[allenfi]

http://www.enermax.com.tw/uc-a8fatr4.htm

Oops, here is the link i was talking about

[DallasDon]

You can attach the sensor next to the heat source you want to monitor.

Like Taping it to the circuit board CPU on a vid card, or wedge it in the base of a heat sink.

The white wires are the heat sensors, report tems within + 2 degrees of the motherboard BIOS.

[allenfi]

Thanks,
It makes alot of sense to me.
is there a special tape or will scotch tape work? I hope that's not an ignorant question. Working on my 1st build .
acrylic blue uv case
intel d875pbz
3.2 gig p4 with h/t
gainward 128mb ultra 1200 video card
audigy2 platinum zs
sony 17 inch dvi-d flat panel with 16ms response
blue us coolermaster fans
green sleeving through-out

Who know's how it will turn out
Been doing alot of reading tho
ty again

[DallasDon]

Duct tape is probably best. It is made to be resisant to heat, as it is really used to seal AC/Heating ducts.

Just need a small piece, and make sure the board is clean.

It even comes in colors now!